HPE Community
BladeSystem - General
1752797 Members
5944 Online
108789 Solutions
New Discussion юеВ

Re: VLAN tagging and tunneling mode on one Shared Uplink Set

 
SOLVED
Go to solution
Andrew_Read
Frequent Advisor

тАО07-27-2008 06:37 PM

тАО07-27-2008 06:37 PM

VLAN tagging and tunneling mode on one Shared Uplink Set

I would like to be able to setup server tagging for VMware and network VLANs for Windows servers on the same uplinks.

A post from last December mentioned this functionality is planned for a future firmware release.

Does anyone know if this is available yet (or an ETA)?

Regards,

Andrew
0 Kudos
3 REPLIES 3
Lmm_1
Honored Contributor

тАО07-29-2008 04:27 AM

тАО07-29-2008 04:27 AM

Solution

Re: VLAN tagging and tunneling mode on one Shared Uplink Set

It should be included on version 1.31, the release will be in a few weeks.

rgds,
Lmm
0 Kudos
Andrew_Read
Frequent Advisor

тАО07-29-2008 06:29 PM

тАО07-29-2008 06:29 PM

Re: VLAN tagging and tunneling mode on one Shared Uplink Set

Thanks for the response.
0 Kudos
Andrew_Read
Frequent Advisor

тАО07-29-2008 06:29 PM

тАО07-29-2008 06:29 PM

Re: VLAN tagging and tunneling mode on one Shared Uplink Set

Closing thread
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.