- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Re: What is the best scenario for enclosure with o...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-26-2018 07:47 PM
08-26-2018 07:47 PM
What is the best scenario for enclosure with one VC module ?
I have one enclosure blade C3000 with 3 blade HP ProLiant BL620c G7.
And I just have one Virtual Connect Flex-10 10Gb Ethernet Module.
How can I config my Virtual Connect ? I little bit confuse, I cannot found suitable scenario for my hardware in Virtual Connect Cookbook
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-28-2018 10:56 AM
08-28-2018 10:56 AM
Re: What is the best scenario for enclosure with one VC module ?
Greetings,
It's not an HPE supported configuration. but it may still work with no redundancy.
I will refer you to page 7 for NIC port mapping for c3000.
https://support.hpe.com/hpsc/doc/public/display?docId=c01310406
VC configuration like network creation, server profile etc will remain the same as c7000.
I will refer you to page 14 on the VC c-Class BladeSystem Setup and Install Guide.
http://h20628.www2.hp.com/km-ext/kmcsdirect/emr_na-c05132897-3.pdf
Hope that helps
I am an HPE Employee.