Using two different switches in bays 1 & 2

[chuckk281]

Frank had a customer issue:

************

Is using (2) different Ethernet interconnects in Bays 1 & 2 supported?  I haven’t been asked this before, and just received a question from a customer who is trying it (see customer notes below) Is the ‘hot swap’ the possible issue?  Should they do a shutdown and reboot of the enclosure?

**************

Reply from Dan:

**************

2 different switches, yes

2 different speeds, no

From the 465c G7 QuickSpecs

NOTE: Each port is autosensing 1 Gb / 10 Gb, and can interoperate with 1 Gb HP BladeSystem c-Class interconnect components. ***Both ports will operate at the same speed***.

*************

Other comments?