HPE Community
BladeSystem - General
1753466 Members
4761 Online
108794 Solutions
New Discussion

Connect ProLiant BL460c Gen9 to two SAN Fabrics

 
GaryDeTaxi
Occasional Contributor

‎03-14-2018 02:45 PM

‎03-14-2018 02:45 PM

Connect ProLiant BL460c Gen9 to two SAN Fabrics

I have: HPE BladeSystem Enclosure C7000 with Interconnect Bay port 1 connected to SAN1 and port 2 connected to SAN2.

Is it possible to connect HPE ProLiant BL460c Gen9 Server Blade to both SAN Fabrics: SAN1 and SAN2 with one Mezzanine Card? If not, how I could do it?

0 Kudos
Reply
2 REPLIES 2
Torsten.
Acclaimed Contributor

‎03-15-2018 01:28 AM

‎03-15-2018 01:28 AM

Re: Connect ProLiant BL460c Gen9 to two SAN Fabrics

The mezzanine card maps to both sides of the interconnects, see

127358


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
GaryDeTaxi
Occasional Contributor

‎03-15-2018 12:20 PM

‎03-15-2018 12:20 PM

Re: Connect ProLiant BL460c Gen9 to two SAN Fabrics

I have only M1 and Bays 2 and 3.

Is it possible to remap Port 2 of M1 to Bay 3 instead of 4? Or it is hardwired?

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.