HPE Community
BladeSystem - General
1753802 Members
8075 Online
108805 Solutions
New Discussion

Integrity blades and Virtual Connect

 
J. Martens
New Member

‎06-28-2009 12:03 PM

‎06-28-2009 12:03 PM

Integrity blades and Virtual Connect

Anybody has configured Virtual Connect for Integrity Blades (BL860c/BL870c) and VLANs in an active/standby configuration using two 1/10Gb VC-Enet modules? A lot of possible configurations are descibed in the VC Ethernet cookbook but with one to use for Integrity blades? Thansk in advace. JackM
0 Kudos
Reply
1 REPLY 1
vcblades
Frequent Advisor

‎06-28-2009 05:07 PM

‎06-28-2009 05:07 PM

Integrity blades and Virtual Connect

I haven't yet but it should not be no different than a full height blade - Also, you can easily configure VLANs in active/standby config using 2 1/10GB VC-Enet modules. Check with your network admin on which scenario is required from the cookbook - Scenario's 3~8 for your case.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.