HPE Community
BladeSystem - General
1753905 Members
9901 Online
108810 Solutions
New Discussion

VC Switch | Commands and Output

 
grinningdevil
Frequent Advisor

‎01-29-2016 02:28 AM

‎01-29-2016 02:28 AM

VC Switch | Commands and Output

Hello Guys ! 

Few direct questions if someone can please help me out - 

  • What is the CLI command to check that a VC switch is in Access gateway mode (NPIV)
  • What is the expected output of this command

 

  • If the switch is not in access gateway mode, what is the CLI command to configure it in access gateway mode (NPIV)
  • What is the expected output of this command.


Thanks !!!

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.