HPE Community
Communications and Wireless
1855287 Members
6573 Online
104109 Solutions
New Discussion

Re: Wireless Router/Access Point...

 
reesea
Occasional Advisor

‎03-22-2010 03:30 PM

‎03-22-2010 03:30 PM

Wireless Router/Access Point...

Hello,

I have a Net Gear 8802.11a/g Prosafe Dual Band Wireless Access Point Model: WAG302 that is not allowing me to configure it. The setup I used to try to configure it was Ethernet going from router to pc/laptop and typing the default address, after re-setting it for 30 to 60 seconds. When I type in the default IP address, the page will time out and never get into setup. But it does work when I associate it to a switch that has the network already established and then it starts acting like an access point as it should, but I would at least like to have some security measures within it.
Any help would be appreciated.
0 Kudos
1 REPLY 1
reesea
Occasional Advisor

‎03-28-2010 04:30 AM

‎03-28-2010 04:30 AM

Re: Wireless Router/Access Point...

Router Access point was out of range of LAN, configure settings to my PC and was able establish connection.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.