HPE Community
Disk Enclosures
1753971 Members
7609 Online
108811 Solutions
New Discussion юеВ

VA7100 - WARNING STATE - Device CLAIMED in HP-UX11.11 but no connection via cvui

 
SOLVED
Go to solution
Cresswell Williams
Frequent Advisor

тАО02-12-2008 01:56 AM

тАО02-12-2008 01:56 AM

VA7100 - WARNING STATE - Device CLAIMED in HP-UX11.11 but no connection via cvui

Hi Experts

I have a VA7100, with no data on it. I started it up, and connected to it via a serial cable, and it went directly into the WARNING STATE prompt.

I did an ioscan -fn from my HP-UX11.11 L-class server, and it picks up the array (CLAIMED), but I can still not connect to the va through cvui. Any suggestions?

Cresswell
0 Kudos
Reply
2 REPLIES 2
Torsten.
Acclaimed Contributor

тАО02-12-2008 03:30 AM

тАО02-12-2008 03:30 AM

Solution

Re: VA7100 - WARNING STATE - Device CLAIMED in HP-UX11.11 but no connection via cvui

From the CLI run
dsp -s

to get more information about the status.

What do you get if you run from the host

# armdiscover

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Reply
Cresswell Williams
Frequent Advisor

тАО02-12-2008 04:18 AM

тАО02-12-2008 04:18 AM

Re: VA7100 - WARNING STATE - Device CLAIMED in HP-UX11.11 but no connection via cvui

Thanks for your reply. armdiscover worked!!
My inexperience in va's is really showing.

Thanks once again
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.