- Community Home
- >
- HPE Community, China
- >
- 服务器
- >
- e3000服务器
- >
- EVA4400无法进行初始化
类别
Company
Local Language
论坛
讨论平台
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
论坛
博客
- 将帖子标记为未读
- 加注书签
- 订阅
- 禁止
- 订阅此主题的 RSS 提要
- 高亮显示此帖
- 打印此帖
- 报告不当内容
修改时间 11-02-2013 01:14 PM
修改时间 11-02-2013 01:14 PM
EVA4400无法进行初始化
客户一台EVA4400从广东搬到北京之后一直未启来过,闲置了三个月后要求维修好,刚开始CV根本找不到存储,并且两个控制器自动来回重启,经过升级firmware,更换电源,中板后CV总算能找到存储了,但就是不能做初始化,最后case升级到二线,二线工程师给了个如何清除metadata数据的文档,做完果然能够初始化存储了,现分享一下:
1. Halt, or otherwise shut down both controllers:
To halt, connect the MSA cable to the manufacturing port of each controller.
See SAW article titled HP StorageWorks 4400 Enterprise Virtual Array - How to Connect to the Controller Serial Line (mfg Port) (mmr_na-192283-3).
Type <cntrl>k . This halts the controller.
^k
Repeat for the second controller, so both are halted.
You should now be at the mindy prompt (:).
2. Type the following:
:df ^j - df = display debug flags, then <cntrl>j for return. Should be 0.
:df 1 ^j - set debug flags to 1 -> prompt for go
:rs - restart this controller
You will then see the following menu.
3. Type f at the prompt (set debug flags).
Enter: f to set/change debug flags during start [1]
p to set/change print flags during start [1ffff]
G or g to start
w to enter system WWID
t to change frontend port type default setting(s)
c to scrub cache
s to scrub disk metadata : s
You will then see the menu again.
4. Type g (Go).
Enter: f to set/change debug flags during start [1]
p to set/change print flags during start [1ffff]
G or g to start
w to enter system WWID
t to change frontend port type default setting(s)
c to scrub cache
s to scrub disk metadata : g
Now you will be prompted to set the debug flags.
6. Type 00000000 , then <cntrl>j (return at mindy).
After Scrub, then init.