Using IPMI over ILO2

[romain0412]

Hi,

I have to monitor some HP Poliant DL380 G6. I've used IPMI protocole on other server (other brand). I wan to use IPMI on ILO2 but I don't find this on the interface.

I've read on an other thread that HP use an another tool, SMASH? I don't know it and don't find how to user it.

[Oscar A. Perez · Accepted solution]

IPMI support was added in the new iLO2 v2.00 that was just released last week.

iLO2 v2.00 Enhancements/New Features

- New HP Intelligent Power Distribution Unit
- Fully Qualified Domain Name (FQDN) for imported certificates
- A Recovery Payload that will help users recover iLO 2 from a failed firmware upgrade via FTP. Additional details can be found - in the new User Guide which can be found at http://www.hp.com/go/ilo
- "IPMI over LAN" functionality. The IPMI 2.0 RMCP+ (or Linux ipmitool "lanplus") protocol is supported with this release.
- IPMI Serial Over LAN (SOL)
- Data Center Manageability Interface (DCMI) v1.0 specification
- Enhanced the "in band" Intelligent Platform Management Interface (IPMI) to comply with the IPMI specification version 2.0

[romain0412]

Great :-D.

But I search this new firmware but I don't find it. I wan't to upgrade the ILO by web acess, since the operating system is not yet available.

Thanks for your great help.

[Oscar A. Perez]

Download Windows Online Component:
ftp://ftp.hp.com/pub/softlib2/software1/sc-windows-fw-ilo/p1443420321/v60898


Download Windows Online Component 64 bit:
ftp://ftp.hp.com/pub/softlib2/software1/sc-windows-fw-ilo/p2023401934/v60896


Download Linux Online Component:
ftp://ftp.hp.com/pub/softlib2/software1/sc-linux-fw-ilo/p1285463034/v60899

[romain0412]

Thanks,

I will try it !