DL320 G6: Search driver for the controller B110i SLES11

[FRAD_1]

Hello,

i want to install SLES 11 on my Proliant DL320 G6 (Smart Array Controlle rB110i)...

I activated the onboard Raid Controller and builded 2 arrays (4 hdd)...

Were can i download the driver for the controller? SLES10 shows all 4 hdd in the setup - i don´t see the array?!?!

Any ideas

[Matti_Kurkela]

You'll need this:

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=15351&prodSeriesId=3929672&swItem=MTX-949d7898462041d69252bc9846&prodNameId=3929673&swEnvOID=4048&swLang=13&taskId=135&mode=4&idx=1

This was found from the standard location for support downloadables for HP Proliant products:

http://www.hp.com/go/support
-> select "Download drivers and software (and firmware"
-> type in your model (i.e "DL320 G6") and press Enter
-> select your OS
-> in this case, look for category "Software - Driver Diskettes". After the basic OS installation is done, you might want to install other stuff too for your convenience (at least check out "Driver - System Management" and "Software - System Management")

MK

[Daniel Frazier]

The hpahcisr driver is required to access the B110i controller as a RAID device.

This driver is not yet available for SLES11, but it should be available soon on hp.com - please check back around mid November.

You can of course use these devices with the open source drivers provided by SLES11, and the distribution-provided software RAID support. But, be warned that there is no migration path to the hpahcisr driver, other than a backup/restore of all of your data.

Also note that hpahcisr is currently available for SLES10.