- Community Home
- >
- Servers and Operating Systems
- >
- Operating Systems
- >
- Operating System - Linux
- >
- Mylex DAC960PL-3
Operating System - Linux
1752808
Members
5954
Online
108789
Solutions
Forums
Categories
Company
Local Language
юдл
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
юдл
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО10-26-2000 09:33 AM
тАО10-26-2000 09:33 AM
Mylex DAC960PL-3
I flashed my Dac960PL - 3 controller with a new firmware/bios update and now it ins?t seen during the system boot.
How i over-ride the rom bios and flash controller again. Which JP I need remove ?
How i over-ride the rom bios and flash controller again. Which JP I need remove ?
Prado
2 REPLIES 2
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО10-26-2000 11:28 PM
тАО10-26-2000 11:28 PM
Re: Mylex DAC960PL-3
are devices attached to it seen or does it just not show up in the SCSI banner? if it's not recognized at all you might try to re-flash it (new or old bios/fw).
An other possibility, less likely, is that it's settings changed. See if you need to enable bios or banner
An other possibility, less likely, is that it's settings changed. See if you need to enable bios or banner
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО10-27-2000 01:51 AM
тАО10-27-2000 01:51 AM
Re: Mylex DAC960PL-3
I try flashed bios again, but aplication returned "The adapter controller not Found".
I check Slot and cables, Ok !
I check Slot and cables, Ok !
Prado
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP