unable to run clusterware package on service guard

[SJ1436]

Hello,

Thanks again.
I did the ioscan and the fc card is claimed .
the fcmsutil just give info about the card, i need to check the initiator type and change it if required. could you please advice ?

Thank you
SJ

[Torsten.]

If you hide all the requested information, you will be alone, I guess.

[SJ1436]

hi all ,

Please find attached the required info.
It is not that I want to hide info , but it is a server at a client and he has some restriction on getting away some information on the system.

Thanks a lot
SJ

[Torsten.]

a previous question was:

"What is the status of the below disks:

/dev/dsk/c6t0d4
/dev/dsk/c6t0d5
/dev/dsk/c6t0d2
/dev/dsk/c8t0d3

Does ioscan display all those as claimed."

All the EVA vdisks are c10... and c11... related to hardware path 0/3/1/.

The card on 0/4/1 does not show devices.


Again, if you use WWN based zoning on the switch - adjust it to the new WWN of the HBA.



The EVA presents vdisks to the servers based on their HBA WWN - you need to adjust the EVA config to present vdisks to this new card.

N_Port Port World Wide Name = 0x50060b000012f0c6

This WWN must be used on the EVA presentation settings!

[SJ1436]

Hi Torsten,

Thanks for your reply.
In fact , this is the problem that there are disks that are not shown by the new added card.
I have already adjusted the zoning configuration , even I deleted the zone and recreate it again , and add it the the zone config and restarted the server, and I always have the same problem.
and since the card is claimed , that's mean that it is working.
anything else can I check ?

Best regards,
SJ

[Torsten.]

I wrote this now multiple times, but now more detailed:

logon to commandview, add the new card in the "hosts" section and present the vdisks to the "new" host entry.


The EVA will NOT present the vdisks to your server because of the changed WWN.

This is the reason why you don't see disks.