unable to run clusterware package on service guard

[Torsten.]

"I have changed the defective FC card , ... do I need to reconfigure anything after the Hardware replacement?"

Do you use WWN based zoning? If you do, you need to adjust the config on the switch.

[Rasheed Tamton]

>I have changed the deffective FC card
Is this FC claimed by ioscan. Otherwise, you have to do a insf -e

You have to deactivate the volume groups for the clusters and make them cluster aware as in my above post and enable it again.

[SJ1436]

Hi Rasheed,

Thanks again.
in fact I have searched the ioscan and found 2 entires for the "fcparray" which corresponds to one card I think (I have 2 cards on each server). on the other server there are 4 entries.
I have made insf -e but nothing changed, I have then restarted the server but it did not help.
what do you think?

Best Regards,
SJ

[SJ1436]

Hello ,

could anyone advise how can I access the initiator settings to check them ??
thanks
SJ

[Rasheed Tamton]

ioscan -fnCctl (look for the initiator)
ioscan -fnCfc

If you have card which is not found by the system then one reason is that it is not seated correctly on the system. You have to inspect the system and see how many of them are there on the system.

[Torsten.]

Could you post the output of "ioscan -fn" please?

Did you already check the zoning configured on your switches?

Maybe you need to adjust the WWN based presentation on your array too.

[SJ1436]

Hi,

Thanks for your answers.
how can I check and edit the "Initiator Type" settings ?

Best regards

[Torsten.]

For FC cards the HBA will sense the settings with the switch - you can't change them on the host.
Check with (example):

# fcmsutil /dev/fcd0

(or whatever applies).

[Rasheed Tamton]

It is better to give the output of ioscan -fn as asked by Torsten. That would give a good idea about the hw in your system.

ioscan -fnCfc
will show the dev path for the FCs and do fcmsutil on it.

[SJ1436]

Hello,

Thanks again.
I did the ioscan and the fc card is claimed .
the fcmsutil just give info about the card, i need to check the initiator type and change it if required. could you please advice ?

Thanks you
SJ