HPE Community
HPE 9000 and HPE e3000 Servers
1752604 Members
4611 Online
108788 Solutions
New Discussion юеВ

BCH Memory WARNING: Non-destructive test bit was set

 
SOLVED
Go to solution
Dane Van Steenwyk
Frequent Advisor

тАО06-28-2005 10:07 AM

тАО06-28-2005 10:07 AM

BCH Memory WARNING: Non-destructive test bit was set

I have an L2000 server and when it comes to the BCH menu(Main Menu) it says WARNING: Non-destructive test bit was set, so memory was not tested destructively. It also says for information only but I just want to know if there is a way to fix it?? Any help would be much appreciated.
0 Kudos
2 REPLIES 2
timmy b.
Honored Contributor

тАО06-28-2005 03:37 PM

тАО06-28-2005 03:37 PM

Solution

Re: BCH Memory WARNING: Non-destructive test bit was set

Check FastBoot, I think it's in the COnfiguration screen at BCH. I believe having FastBoot turned ON will give you this error. It bypasses much of the memory tests, thereby speeding up your boot time, but this isn't something that you want to leave turned on all the time. It's mainly used when you plan on doing several reboots in a row.
There are 10 kinds of people in this world: Those who understand Binary, and those who don't.
Dane Van Steenwyk
Frequent Advisor

тАО06-29-2005 01:53 AM

тАО06-29-2005 01:53 AM

Re: BCH Memory WARNING: Non-destructive test bit was set

I thought I had FastBoot disabled but I just turned it off again and rebooted and it worked. Thanks for your help.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.