console log

[navin]

how to see console log in GSP
thanks

[Dennis Handly]

Control-B to get into the GSP. And I think SL will show logs. You can use HE to get help on the commands.

[Taifur]

Hi Navin,

From gsp

use HE for command

you can check it by SL for all log

If helps, pls assign point.

Rgds//
Taifur

[Jozef_Novak]

Hello,

log in to the GSP. From the main menu, select SL (Show Event Logs). Now select either Foward Progress Log or Event Log. Next, setup filter (you can view either all logs or filter them out based on alert level). After the logs are displayed, you can browse them using + or - key.

HTH,
J.

[Senthil-kumar]

From GSP prompt, type CL for Console logs

[Torsten.]

(C)onsole (L)ogs = cl

GSP> he li


HE LI


==== GSP Help ============================================(Operator)========
AC : Alert display Configuration PS : Power management module Status
CA : Configure asynch/serial ports RS : Reset System through RST signal
CL : Console Log- view console history SDM : Set Display Mode (hex or text)
CO : COnsole- return to console mode SE : SEssion- log into the system
CSP : Connect to remote Service Proc. SL : Show Logs (chassis code buffer)
DI : DIsconnect remote or LAN console SS : System Status of proc. modules
EL : Enable/disable LAN access TC : Reset via Transfer of Control
ER : Enable/disable Remote/modem TE : TEll- send a msg. to other users
HE : Display HElp for menu or command VFP : Virtual Front Panel display
LS : LAN Status WHO : Display connected GSP users
MR : Modem Reset XD : Diagnostics and/or Reset of GSP
MS : Modem Status XU : Upgrade the GSP Firmware
PC : Remote Power Control


GSP> cl