HPE Community
HPE 9000 and HPE e3000 Servers
1751788 Members
5274 Online
108781 Solutions
New Discussion юеВ

Re: Cpu enable

 
Waugh
Frequent Advisor

тАО10-17-2008 05:39 AM

тАО10-17-2008 05:39 AM

Cpu enable

Hi,

How to enable the CPU in NPAR.


Regards
Rkumar
0 Kudos
3 REPLIES 3
Ron Irving
Trusted Contributor

тАО10-17-2008 10:26 AM

тАО10-17-2008 10:26 AM

Re: Cpu enable

Hi there!!

What type of system? If it's a PA-RISC system, the PDC menu would be a good place to start.

HTH

ron
Should have been an astronaut.
0 Kudos
Waugh
Frequent Advisor

тАО10-17-2008 05:58 PM

тАО10-17-2008 05:58 PM

Re: Cpu enable

Hi ,

Its a PA-Rics system

Regards
Rkumar
0 Kudos
Ron Irving
Trusted Contributor

тАО10-20-2008 03:43 AM

тАО10-20-2008 03:43 AM

Re: Cpu enable

Hi again!

From the PDC main menu, type 'co' for configuration. Then, I believe it's cpu# on. For example, if it's cpu3 that's deconfigured, type 'cpu3 on'

You will have to reboot at that time. Your cpu should come back at that time. If it doesn't, you will likely have to replace it. Do you have hardware maintenance on this system?

HTH

Ron
Should have been an astronaut.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.