- Community Home
- >
- Servers and Operating Systems
- >
- Legacy
- >
- HPE 9000 and HPE e3000 Servers
- >
- FPAR_PHASE_IS_ACTIVE
HPE 9000 and HPE e3000 Servers
1752604
Members
4334
Online
108788
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-19-2007 10:29 PM
02-19-2007 10:29 PM
FPAR_PHASE_IS_ACTIVE
Hello,
one of our SDs npars in vpar-mode stops while booting at the point FPAR_PHASE_IS_ACTIVE. The cells have had joined the partiton, but EFI was not loaded. After a reset the Partition booted without errors.
Does someone knows, what the bootstep FPAR_PHASE_IS_ACTIVE means?
Thank you
Regards
Rudolf
one of our SDs npars in vpar-mode stops while booting at the point FPAR_PHASE_IS_ACTIVE. The cells have had joined the partiton, but EFI was not loaded. After a reset the Partition booted without errors.
Does someone knows, what the bootstep FPAR_PHASE_IS_ACTIVE means?
Thank you
Regards
Rudolf
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP