happen to error after os restore using ignite - 0xA0E000C01100B000

[원유광]

hello~

I'm using hpux11.00 on L1000 unit.
L1000 unit appeared as below on dmesg.
-- below --
msgcnt 54 vxfs: mesg 016: vx_ilisterr - / file system error reading inode 1825
msgcnt 55 vxfs: mesg 016: vx_ilisterr - / file system error reading inode 1825
msgcnt 56 vxfs: mesg 016: vx_ilisterr - / file system error reading inode 1825
msgcnt 57 vxfs: mesg 016: vx_ilisterr - / file system error reading inode 1825

so, I'm change root disk after ignite backup
and then restore os on new disk by ignite tape.
After finished restore normally, appeared error message

************* SYSTEM ALERT **************
SYSTEM NAME: tv3
DATE: 12/20/2004 TIME: 14:36:32
ALERT LEVEL: 12 = Software failure

REASON FOR ALERT
SOURCE: 1 = processor
SOURCE DETAIL: 1 = processor general SOURCE ID: 0
PROBLEM DETAIL: 0 = no problem detail

LEDs: RUN ATTENTION FAULT REMOTE POWER
FLASH FLASH FLASH ON ON
LED State: Unexpected Reboot. Running non-OS code. Non-critical error detected.
Check Chassis and Console Logs for error messages.

0xA0E000C01100B000 00000000 000005E9 - type 20 = major change in system state
0x58E008C01100B000 0000680B 140E2420 - type 11 = Timestamp 12/20/2004 14:36:32
A: ack read of this entry - X: Disable all future alert messages


Please Help me~~~~

[Stefan Stechemesser]

Hi ì ì  ê´ ,

the System Alert tells you that the new installed OS has crashed with a software failure ("system panic").
I would recomend to observe the console log with the GSP "cl" command. In most of the cases you see a line with the reason for the panic, f.e.

IO hang, hardware probe timed out or maybe root filesystem not found.

You cannot get the reason for thge crash from the System Alert only.

best regards

Stefan