Lan console on A class

[SM_3]

Do you know of any docs that detail the set-up for a Lan console for the A class server.

Should i see a separate entry in ioscan for the lan console?
Well I don't.

Thanks

[Denver Osborn]

I don't think you'd see this in an ioscan, it's part of the gsp.

Have a look at this post and read Bill H's reply.

http://forums1.itrc.hp.com/service/forums/parseCurl.do?CURL=%2Fcm%2FQuestionAnswer%2F1%2C%2C0x846a87dc4d7dd5118ff00090279cd0f9%2C00.html

There is also a h/w manual for the A400/A500's here.

http://www.docs.hp.com/hpux/onlinedocs/2411/rp24xx_customer.pdf

Hope this helps,
-denver

[Michael Steele_2]

Search on "lan console" for the link and attachment.

http://docs.hp.com/hpux/onlinedocs/2409/bcc_en.pdf

Here is part of the GSP command set look for:

Remote
DI
Disconnect remote or LAN console

Remote
DR
Disable remote or LAN console access

Remote
ER
Enable remote or LAN console access

[SM_3]

once the lan console is enabled and configured how do I access the gsp remotely?

thanks

[Camel_1]

Open an internet browser from your desktop and then enter the IP address of the LAN console which you configured.

[Hari Kumar]

U can
telnet
or
Open browser and
http://

[Michael Steele_2]

Yes, just telnet to the GSP ip, but two rules to remember.

a) The speed and duplex are printed on the back of the A class server where the ethernet cable connects. Note this and match you SWITCH port to it. It will something like 10 BaseT full duplex.

b1) <'ctrl c'>
b2) E&F together to take over the console when first telneting in.

<&> - together

[Michael Steele_2]

Yes, just telnet to the GSP ip, but two rules to remember.

a) The speed and duplex are printed on the back of the A class server where the ethernet cable connects. Note this and match you SWITCH port to it. It will something like 10 BaseT full duplex.

b1) <'ctrl c'>
b2) E&F together to take over the console when first telneting in.

<&> - together

ohh

c)

[SM_3]

I'll have to verify the GSP session later now.

But when I do I'll get back to you. That way I can assign appropiate points.

thanks for the help.