LED red rp3410 over temp

[LEO SIMON_1]

Hi

I had one rp3410 with LED front panel red because of over temperature.
I can't turn off the LED after reading the log from MP.
Is there any other way to turn off the led power off without shutdown and disconnect the power supply ?
I also test to reset MP using XD - R without result

Thanks

Leo

[Torsten.]

Hi,

perhaps there is another reason for the light like a full BMC log.
Review the logs again and clear the logs if needed.
I would also check if a new firmware is available for your system.

see
http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=15351&prodSeriesId=2512012&prodNameId=406773&swEnvOID=54&swLang=13&mode=2&taskId=135&swItem=pf-45260-1

[LEO SIMON_1]

Hi Torsten,

I had already clean all the log and the firmware also the newest.

But the LED still red

[LEO SIMON_1]

I just found we can reset BMC using MP command RB to turn off the LED
But on the newest FW this rb is not allowed to power down LED

[LEO SIMON_1]

Case closed