HPE Community
HPE 9000 and HPE e3000 Servers
1753899 Members
7775 Online
108809 Solutions
New Discussion

Remote console disconnects when dialing in.

 
Kurt Hockenbury
New Member

‎07-21-2006 04:53 AM

‎07-21-2006 04:53 AM

Remote console disconnects when dialing in.

I am attempting to configure remote console for dial-in before an OS upgrade. Modem is hooked up, and I went through the GSP configuration for remote console.

Right now when I dial in, I connect, and get the GSP login prompt. I can hit enter quickly (no password set up yet) and even to the GSP prompt, but whether or not I log in, I get disconnected almost immediately. I haven't timed it, but I'd say about 5 seconds is about as long as it stays connected.

Help? I'm not sure what else to try, I've looked through the GSP options, and things look ok there as best I can tell.
0 Kudos
1 REPLY 1
Kurt Hockenbury
New Member

‎07-21-2006 07:17 AM

‎07-21-2006 07:17 AM

Re: Remote console disconnects when dialing in.

Got it. Had to change the signalling from CCITT to Bell.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.