HPE 9000 and HPE e3000 Servers
1748123 Members
3330 Online
108758 Solutions
New Discussion юеВ

RP4440 powers on but then automatically powers off a few seconds later.

 
qiyongquan
Occasional Advisor

RP4440 powers on but then automatically powers off a few seconds later.

i power on the system,after a few second,the system power off automatically,and the system led is flashing red.
How to solve the problem?
the processor fault or the processor extender board fault ?
Thanks all;
Here is the sel messages:

Log Entry 3: 16 Jul 2009 07:41:15
Alert Level 3: Warning
Keyword: Type-02 076f03 487171
No events were received from system firmware
Logged by: Baseboard Management Controller;
Sensor: Processor
Data1: FRB2/Hang in POST failure
0x204A5ED99B020040 FFFF036F00070300

Log Entry 1: 16 Jul 2009 08:24:10
Alert Level 5: Critical
Keyword: Type-02 020703 132867
Voltage reached critical level
Logged by: Baseboard Management Controller;
Sensor: Voltage - 1.2V Status
Data1: transition to Non-recoverable from less severe
0x204A5EE3AA020010 FFFF0307C7020300

Log Entry 0:
Alert Level 0: Minor Forward Progress
Keyword: CPU_API_DEBUG_INFO
Cpu Debug Information
Logged by: System Firmware 0
Data: Implementation dependent data field
0x16000CC600E00000 0000002700000000
4 REPLIES 4
JKytsi
Honored Contributor

Re: RP4440 powers on but then automatically powers off a few seconds later.

Do You have more than one CPU module ? If so, try with only one and swap with the other(s) if first fails. There You should see if it's the CPU board or CPU module faulting.
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
qiyongquan
Occasional Advisor

Re: RP4440 powers on but then automatically powers off a few seconds later.

this only one processor installed!

Michal Kapalka (mikap)
Honored Contributor

Re: RP4440 powers on but then automatically powers off a few seconds later.

hi,

in this case, i would contact HP directly.

mikap
Kishore Anand
Occasional Advisor

Re: RP4440 powers on but then automatically powers off a few seconds later.

This looks like an issue with the Processor Extender Board.

As this is a single processor setup, we can't swap and check.