HPE Community
HPE 9000 and HPE e3000 Servers
1752565 Members
5713 Online
108788 Solutions
New Discussion юеВ

Re: RP7410 configuration

 
SOLVED
Go to solution
EMCD
Frequent Advisor

тАО02-08-2007 02:53 AM

тАО02-08-2007 02:53 AM

RP7410 configuration

I have a technical question for some of you...

RP7410 Cell/Coherence Controllers (CC) in each cell use the SBA link to directly connect to IO. It looks to me that cell 0 connects to IO chassis 0 and cell 1 to IO chassis 1. Does this mean if your running only one cell board in your partition (cell 1), you can only access half of your I/O (chassis 1). Then in order to access the rest of your IO (chassis 0), you will need to have two cell boards in place?

Do I totally have this wrong as I'm only going by the diagrams in the manual.
0 Kudos
3 REPLIES 3
Torsten.
Acclaimed Contributor

тАО02-08-2007 04:14 AM

тАО02-08-2007 04:14 AM

Solution

Re: RP7410 configuration

You are right!
Each half is connected to a cell.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Edward J. Segura
Frequent Advisor

тАО02-15-2007 09:08 PM

тАО02-15-2007 09:08 PM

Re: RP7410 configuration

Correct! I just installed another cell board in order to use the other 8 slots i.e cell 1.
0 Kudos
EMCD
Frequent Advisor

тАО02-16-2007 12:29 AM

тАО02-16-2007 12:29 AM

Re: RP7410 configuration

Thanks guys...
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.