RP8400 update fw

[higo]

Hi,

I have update the firmware of my RP8400 with a single cell, each time i log to MP i have execute CC commande to redifine a profile cell, the vfp and co commande are also desable. Sysrev give an ok situation

MP:CM> sysrev

Cabinet FPGA and Firmware revision report

System Backplane : GPM FM OSP
------- ------- ----
1.002 1.002 1.002

PCI Backplane : LPM HS
------- -------
1.002 1.000

LPM BOB DRAIN PDHC PDC
------- ------- ------- ------- -------
CELL 0 : 2.002 1.000 1.001 2.004 17.009
CELL 1 : 0.000 0.000 0.000 0.000 0.000
CELL 2 : 0.000 0.000 0.000 0.000 0.000
CELL 3 : 0.000 0.000 0.000 0.000 0.000

FPGA MP
------- -------
Master Core IO : 2.008 4.025
Slave Core IO : 0.000 0.000

Nedd help.

thanks

[Andrew Rutter]

hi,

after the reboot for the firmware update have you powered the cabinet, cells and io cage all back on through the MP?

what does the power status show in the mp for all the system

Andy

[higo]

Hi,

thanks Andrew, please find the attached file of PS.

Please note that the ID cmd gives

ERROR: reading Model String

no profile is defined each time i power ON / OFF the cabinet, i have to execute CC cmd to redifined it. the configuration is keeped.
the battery looks good !!!

thanks for any help