HPE Community
HPE 9000 and HPE e3000 Servers
1753365 Members
5436 Online
108792 Solutions
New Discussion

sysrev shows OSP revision on rp7410 as 0.000

 
vladimir_1
Frequent Advisor

‎11-30-2006 02:42 AM

‎11-30-2006 02:42 AM

sysrev shows OSP revision on rp7410 as 0.000

Run OSP utility also shows its current FPGA version as 0.000. An attempt to upgrade it gives:
Unable to read the OSP ID register, is the OSP programmed?

Power cycle with removing power cords did not help. What's next? Replace system backplane?

Thnx.
0 Kudos
1 REPLY 1
Joshua Scott
Honored Contributor

‎12-08-2006 06:58 AM

‎12-08-2006 06:58 AM

Re: sysrev shows OSP revision on rp7410 as 0.000

Yes, the OSP FPGA (ROM chip) is on the system backplane. Typically when the revision shows as 0.000, it indicates a failed component. Did you have a power failure while attempting to upgrade the firmware recently?

Replacing the backplane would be the next step.

Josh
What are the chances...
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.