I cant use web tools on hp AM867A SAN switch

[David_711]

Hi everyone,
I have a problem with a hp AM867A San switch, i cant use the web tools on this switch.
I check the configuration and cant saw
any information about webtools. But on the quickspec say that webtools is supported on this switch.
Somebody has experience with this model of swicth??, any idea??
Please help.
Thanks,

[marsh_1]

hi,

what exactly happens when you try to open the web page for the address on the switch ?
which browsers have you used ?

[Niels Vejrup Pedersen]

I've used webtools on that switch model without any issue.

Do you get any error ? (Java)

Please provide more info.

Regards

[David_711]

HI,I used internet explorer. when i try to enter to the IP address of the switch, this not conected. I download the configuration file with the command configupload, on this file i don't saw any line correspond to the webtools. On other switch i can see some lines of webtools.
I and upload the configuration of my switch.
Please help.

[IBaltay]

Hi,
certain Webtools functionality have been migrated to the DCFM... inlcuding zoning, this thread could help you...

http://forums11.itrc.hp.com/service/forums/questionanswer.do?threadId=1356169

[David_711]

Hi Niels,
You say that you have the same switches.
Please tell me, what procedure do you do to configure webtools on this switches model??, what fos version do you have?
Thanks to all!.

[Niels Vejrup Pedersen]

Hello,

I don't have the switches with me here, but i always set the ip addres via console cable, and then just access the ip address from a browser.

Regards,

[David_711]

Hi,
The problem is the firmware version.
Zoning administration on webtools has been moving to fabric manager since 6.1.1a firmware version.

Thanks,