HPE OneView for VMware vcenter version 8.0

[paolo marin]

I have installed and configured the HPE OneView for VMware vcenter appliance version 8.0

The issue that I am experiencing is when I am adding the 3PAR StoreServ the Model and Firmware are "blank" .

The 3PAR credential and dns anme are correct and certificate is correct.

Please advice.

Thanks

[paolo marin]

From the vcenetr point of view I cannot see the properties of the array, not avaiable.

see attached.

I have restarted the CIM on the 3par array with no results

Anyone experienced this issue?

[ChrisLynch]

What 3PAR firmware version do you have on your storage system?  You may have a newer version that the vCenter Plugin does not support yet.

[paolo marin]

Sorry for the late reply.

OS 3.2.2 - MU2 (patch up to P33)

[Edward L. Haletky]

Hello,

Are you using a separate network for the 3Par management layer? Or is it the same management network as ESXi and OV4VC? I tried routing everything through a gateway to gain access to my storage and it would not work either. OV4VC had to be on the same network as my storage device. I also made sure that 2nd NIC was marked as Management.

Best regards,

Edward Haletky