- Community Home
- >
- Servers and Operating Systems
- >
- HPE Synergy
- >
- HPE Synergy
- >
- Synergy Chassis Interconnect: No Statistics
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-14-2019 08:33 AM
05-14-2019 08:33 AM
Synergy Chassis Interconnect: No Statistics
In Interconnects --> [40Gb Interconnect] --> [Uplink or Downlink Ports] --> Port --> Statistcs
I get the message "No Statistics"
In the Logical Interconnect I have utilization Sampling enabled. In fact, I just disabled it and re-enabled it. Is there anywhere else that I have to tick a box to get utilization sampling?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-22-2019 11:36 AM
05-22-2019 11:36 AM
Re: Synergy Chassis Interconnect: No Statistics
Hello,
There is no other settings to enable statistics display.
You could try following steps to see if it works:
1) Refresh the Frame which has the interconnect installed
2) Refresh the interconnect module itself
3) Reset the active link module (Frame -> Actions - reset link modules) and wait for refresh to complete
4) Reboot OneView
In case none of these actions helps, please post the version of OneView and VC firmware to check further.
I am an HPE Employee