synergy mezzazine card virtual nic support

[atileren]

I'm the newbie at the synergy. I don't understand a few step. How can do connect from mezzazine card connect to interconnect? And how much support a virtual nic (Flexnic I guess they're both same) each mezzazine card? 

[Sharis]

Hello,

Welcome to Synergy !.

I think you are looking for how the port mapping is done ?

In synergy blade we have 3820c CNA card used mostly.

This is a Dual port Mezz card and its port named as below.

Mezz 3:1  >> This is hardwired connection to  VC module in ICM 3 >> VC module port number is equal to Server Bay number 1.  (Example: Mezz 3:1 port of Blade 1 is downlink Port 1 of VC module in ICM 3)

Mezz 3:2 >> This is hardwired connection to  VC module in ICM 6. >> VC module port number is equal to Server Bay number 1.  (Example: Mezz 3:2 port of Blade 1 is downlink Port 1 of VC module in ICM 6)

Each port of Mezz card support 4 Flex NICs.

Mezz 3:1-a, 3:1-b, 3:1-c & 3:1-d

Mezz 3:2-a, 3:2-b, 3:2-c & 3:2-d

Hope this helps.