1747997 Members
4534 Online
108756 Solutions
New Discussion юеВ

Ignite Upgrade

 
SOLVED
Go to solution
Tim Hempstead
Frequent Advisor

Ignite Upgrade

We currently running 11i (Patched to Dec '03) on a Superdome with 2 NPars. Currently Ignite-UX Version B.3.6.82 is installed.

We are going to be doing some work over the next couple of months to convert to VPars and want to make sure that the various bits of software are up to date before doing this.

If we upgrade to the latest release of Ignite-UX, (5.3.x), are we going to need an outage to do so, i.e. do we need to reboot the NPar during the install?

Thanks

Tim
3 REPLIES 3
Joseph Loo
Honored Contributor
Solution

Re: Ignite Upgrade

hi,

as far as i know, after installation of Ignite-UX (be it upgrade or new install), re-boot is not require.

however, it would be good if you swremove the old version before installing the latest ignite. do note that the full installation of the 5.3.x is about 250MB.

hope this help.

regards.
what you do not see does not mean you should not believe
G. Vrijhoeven
Honored Contributor

Re: Ignite Upgrade

Hi Tim,

The ignite installation does not require a reboot . If you need to add a tape driver/patch to the O.S. that might require a reboot ( driver does).

Check this link:

http://www.software.hp.com/products/IUX/docs/sysadm.html#Chapter-1

Regards,

Gideon

Tim Hempstead
Frequent Advisor

Re: Ignite Upgrade

Many thanks to Joseph and Gideon.

Tim