Infosight with DL380 Gen10 Servers

[tonymcmillan]

We installed two servers initially with dual 800-watt 110V power supplies and later upgraded them to 1600-watt 220V power supplies. However, a couple of months have passed and I noticed that InfoSight still displays them with the original 800-watt power supplies.

What do we do to get InfoSight to rescan the server?

[Candhade]

Suggestions:

1. Check in the ILO Amplifier pack if this server is showing the right information.

2.  If Yes, then we can maybe remove the server from the iLO Amplifier discovered servers and then add it back. 

3. If required, we can then disconnect iLO Amp from Infosight and re-establish the connection. This can be last as it should refresh all the server information in Infosight (not only the affected one).