Operating System - Linux
1748195 Members
3040 Online
108759 Solutions
New Discussion

Re: Health agents cannot find P410i controller

 
snednarb
Collector

Health agents cannot find P410i controller

I have a fresh install of Ubuntu 11.04 (Natty) x64 on a BL460c G7 with a P410i Smart Array controller. I have the latest agents installed (8.7.0.1) from http://downloads.linux.hp.com/SDR/downloads/ProLiantSupportPack/Ubuntu/pool/non-free/

 

Natty comes with the hpsa driver for scsi and this is used instead of the older cciss driver.

 

It appears that the health agents for the SMH and SNMP do not support hpsa or at least cannot find this card.

 

According to http://h20000.www2.hp.com/bc/docs/support/SupportManual/c02677069/c02677069.pdf:

<<

Health monitoring
The HP Systems Management Homepage (SMH) and SNMP Storage Agents fully support hpsa for
health and status monitoring

>>

 

However, with a failed drive:

 

  • SMH > Webapps shows that the "hmastor" agent is loaded, however, the storage module on the page reports as green/healthy and has no information besides diskspace.
  • The SNMP points for the cpqDaMibCondition oid return (2) OK.

 

From /var/log/hp-snmp-agents/cma.log:

 

Jan 19 16:21:37 ubuntu cmaidad[1327]: neither SMART2 ARRAY nor CCISS nor HPACHISR drivers are loaded

 

The hpacucli utility and the cciss_vol_status utility from http://cciss.sourceforge.net/ do report the array status correctly.

 

Are there any fixes for these agents forthcoming? Are there any workarounds to have this version of agents recognize this card?

 

Thank you,

 

Branden

 

1 REPLY 1
cobradevil
New Member

Re: Health agents cannot find P410i controller

I have the exact same error but then on the rhel 6.2 kernel used within proxmox.

 

 

The hpacucli tools shows disk info and array status but the smh only shows the disk space info.

 

When using the hpsa-3.0.0-2 driver from cciss.sf.net then i get the same log messages but then an snmpwalk shows the correct information and also the smh.

 

I also have installed the rhel 9.0 support pack on the proxmox (debian squeeze based) system but there i have the same issues.

 

see my thread on the proxmox forum:

http://forum.proxmox.com/threads/9160-HP-proliant-support-pack-not-recognizing-the-smartarray-controller-DL360-g7

 

Regards,


William