HPE Community
Operating System - Linux
1753664 Members
5791 Online
108798 Solutions
New Discussion

remove discovered device and re-discover

 
BradV
Esteemed Contributor

‎06-29-2012 08:17 AM

‎06-29-2012 08:17 AM

remove discovered device and re-discover

Hi,

 

I have a c7000 with two 3Gb SAS switches in interconnect bays 5 & 6.  When I did the discovery from my insight control server, I hadn't noticed that the two switches had 169.254.0.0 addresses and not the addresses I assigned through epiba.  I did a reset on each and they picked up the correct ip addresses.  However, I can't figure out how to tell insight control to re-discover the switches.  Any suggestions?

 

Thanks!

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.