ISEE for HP-UX and how to ?

[Srikanth Arunachalam]

Hi ,

I need to install ISEE for on our Rx7620 platform that consists of HP-UX 11.23i and HP OpenVMS 8.2 (itanium).

We have SAN storage of EVA6000 and that we want to monitor automated script to monitor the SAN disk and processor. We want to understand the installation procedures, how to document for monitoring processor SAN disk and other EVA related monitoring tools at the earliest please.

Thanks,
Srikanth

[Torsten.]

ISEE on HP-UX can monitor the server but not the EVA.

The procedure is different.

ISEE for EVA must be installed on the management server (where commandview EVA runs), together with WEBES and some other tools.

Ask your HP support!

They can help you to get this working!

[Marcin O.]

Hi
ISEE monitors servers, to monitor EVA you must install ex. SANMaster on EVA appliance.

Thanks
Marcin

[Torsten. · Accepted solution]

This is not 100% right.

To monitor an EVA, you need to install and configure WEBES on the management server. This will monitor the array. ISEE will transfer the messages to HP support. Together with OSEM you can monitor the array and the management server.

Of course you should set up ISEE on your rx-server too. But this will monitor the server only, more or less.

[Srikanth Arunachalam]

Hi,

Thanks for your replies. Can you please let me know how to install ISEE? What port should be made available for this purpose.

Thanks,
Srikanth

[Torsten.]

For the HP-UX server it is easy - it should already be pre-installed. If not, visit

http://h20219.www2.hp.com/services/cache/10710-0-0-225-121.aspx?jumpid=reg_R1002_USEN

Use a browser and go to

your_servers_address:5060/start.html

and do the config. That's it.

For the EVA it is a bit more complicated. I would suggest to ask your HP support.

More information:

http://h20219.www2.hp.com/services/cache/10709-0-0-225-121.html

[tkc]

hi srikanth, do check connectivity between the rx7620 to the hp back-end first. you should be able to have port 80 opened in your firewall or using your web-proxy to isee.asiapac.hp.com. this is also the same for the SAN Management Appliance (SMA) of the EVA.

[Srikanth Arunachalam]

Hi,

How do I open port 80 from firewall. Is it possible to do within the HP-UX server please.

Thanks,
Srikanth

[Torsten.]

"How do I open port 80 from firewall?"

Ask your network team.
You cannot do this from your server.

[Srikanth Arunachalam]

Hi,

Sorry, how do I check if port 80 is available for inbound and outbound network connection from the server. I need to get back to network team with appropriate query. What exactly should I ask them to do with port 80 please. In my /etc/services

It has the following entry.

http 80/tcp www # World Wide Web HTTP


Thanks,
Srikanth