rx1600 Linux Installation

[Brad Gabrielse]

I'm having issues installing RH 3.0 on an rx1600.

I have followed the Linux Enablement Kit instructions, have installed the enablement kit. At reboot the EFI sees no valid CD/DVD device after inserting the distribution media.

I have followed the advice from a similar thread on installation for an rx2600. No luck. Any ideas of what to try next?

Thanks

[Prashant (I am Back)]

Hi,

If i am applying th eoption to go through cd and then run the setup from there. What are the option i am getting. Wht are the content for the cd.

Regards,
Prashant S.

[Prashant (I am Back)]

Hi,

Go through
http://www.docs.hp.com/linux/pdf/5990-8570.pdf


Regards,
Prashant S.

[Alexander Schnapper]

Hi Brad,

you don't need the enablement kit for installing RH 3.0 onto the itanium.
If i think right you have got 4 installation-CDs from Red Hat.

Before RH 3.0 there was RH 2.1 where there was a RH Linux Adv. Server 2.1 Recovery DVD within and that needed hp enablement kit.
RH 3.0 doesn't need that anymore.

Insert the CD1 from the Installation-CDs and in the EFI list up (via "ls") the files in the CD.
Then if there is a file called "elilo.efi" type in elilo.

When "elilo: " turns up, type in (only if you are accessing the rx1600 via console)
"linux console=ttyS0" RETURN

Now the setup should begin and you
just have to follow the instructions.

Greetings from Germany ,
Alexander