LAN Routing
1827821 Members
2518 Online
109969 Solutions
New Discussion

assign IP address to the interfaces

 
SumitP
Occasional Contributor

assign IP address to the interfaces

Hi,

How to assign ip address to the devices/interfaces which is given to the 1950 JG961A switch?

Please help me.

4 REPLIES 4
parnassus
Honored Contributor

Re: assign IP address to the interfaces

Hello @SumitP, can you rephrase your question in a better way? What are you trying to achieve? it's a little bit unclear (to me, at least).


I'm not an HPE Employee
Kudos and Accepted Solution banner
SumitP
Occasional Contributor

Re: assign IP address to the interfaces

Hello @parnassus I have 1950 JG961A switch. To that switch i have connected several devices. My question is how to assign IP addresses to those devices in the web interface. and I have created a vlan under which all 48 ports are untagged. 

parnassus
Honored Contributor

Re: assign IP address to the interfaces

Have you tried to configure DHCP (Dynamic Host Configuration Protocol) Server feature [*] which is supported and provided by your HPE OfficeConnect 1950 Switch?

Here I'm guessing you already haven't a DHCP Server working and configured for the the IPv4 Subnet your devices...indeed you want your Switch to act as DHCP Server for the considered Subnet(s).

[*] GUI Menù Network -> Service -> DHCP will permit you to configure various DHCP Server functions including:

  • Configure DHCP Service and available DHCP Options.
  • Configure the interface to operate in the DHCP Server mode.
  • Configure DHCP Address Pool(s) (with Static or Dynamic Address assignement modes).
  • Configure the IP Address Conflict Detection.

HPE OfficeConnect 1950 Switch Series User Guide valid for R3xxxx software release (August 2016) has a good DHCP (Server) configuration example at page 115 (sheet 123 of 181).


I'm not an HPE Employee
Kudos and Accepted Solution banner
SumitP
Occasional Contributor

Re: assign IP address to the interfaces

Hello @parnassus ,  I tried through DHCP but that is not exactly what I want.

I have posted a another question please check it.

Thank you.