lanadmin error

[M.Thomas]

Hi Admins,

when i run
#lanadmin -x 1
ERROR: Could not process request.

I am getting this error, please let me know how to fix this issue

Thanks in advance

Regards
Thomas

[Luk Vandenbussche]

Thomas,

How many network cards do you have installed.
If you have only one card the command is

lanadmin -x 0

Can you also post the output of lanscan

[Anshumali]

check this thread, might be useful if you are using APA.
http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=1163644

Cheers!
Anshu

[Fabian Briseño]

hello Thomas.

check the follwin threads.

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=1163644

http://www1.itrc.hp.com/service/cki/docDisplay.do?docLocale=en&docId=ucr_na-KMN8606352343_ssb-1


hope they help.

[M.Thomas]

# lanscan
Hardware Station Crd Hdw Net-Interface NM MAC HP-DLPI DLPI
Path Address In# State NamePPA ID Type Support Mjr#
0/1/2/0 0x001560044C1C 0 UP lan0 snap0 1 ETHER Yes 119
0/1/2/1 0x001560044C1D 1 UP lan1 snap1 2 ETHER Yes 119
0/2/1/0 0x001560046422 2 UP lan2 snap2 3 ETHER Yes 119
0/2/1/1 0x001560046423 3 UP lan3 snap3 4 ETHER Yes 119
ustwu030 root / >

[Rita C Workman · Accepted solution]

Hi M.Thomas,

OK...you have more than one card. But is lan1 working ?

I tend to start with the basics and go from there..

Try running:
linkloop

If it comes back and says....OK it's communicating. Otherwise it will report an error and that tells you there's a problem with the card.


Rgrds,
Rita

[M.Thomas]

Dear all,

Thanks for you help

I think some problem with lan card

# linkloop 0x001560044C1D
Link connectivity to LAN station: 0x001560044C1D
error: get_msg2 getmsg failed, errno = 4
-- FAILED
frames sent : 1
frames received correctly : 0
reads that timed out : 1

[whiteknight]

Thomas,

Check your lan cumulative patch, I see this kind of error many times.

please install
PHNE_34427 11.11 LAN product cumulative patch

WK