BIND 8.1.2 - core dump.

[Jaros?aw]

Hello !!!
I have successfully installed and configured from scratch BIND 8.1.2 on HP-UX 11.00 (workstation B2000).
It doesn't working fine. It starts up and works good about 20 minutes and then dumps core without any message.
Configuration is as simply as possible - one domain and two nodes. Workstation B2000 has 2 lan interfaces but one is disabled from BIND configuration (by listen-on parameter). It is only change in default configuration file.

Is it normal behavior of BIND 8.1.2 ???

[steven Burgess_2]

Hi

I would first look at what part of the programme is generating the core file.

I have attached a basic analysis doc

Regards

Steve

[rick jones]

installed from scratch implies installed from source - but BIND 8.1.2 is rather old these days, and I would have thought that anyone installing from source would have used 8.3.mumble (?) from www.isc.org.

hp did provide an 8.1.2 web release, but I thought that too was updated some time ago to at least an 8.2.mumble?

[Wilfred Chau_1]

I would suggest you to use this bind 8.1.2 depot compiled by HP. I had this running for over a year without any problem.

Follow this Url.
http://www.software.hp.com/products/DNS_BIND/index.html