change between the mon to bch

[Mousa55]

Hi
how to change between the mon to bch in virtual partition when i work reboot to virtual partition.i am using this steps but after >reboot the server and interrupt the reboot the server go to MON not to BCH i don't know, how to give back to BCH
BCH>boot pri
ISL>hpux /stand/vpmon
MON>vparload -all
thanks and best regards
Note:the skipping of MON on the BCH this new case and not only

[Torsten.]

You need to reset from the MON prompt (be careful - there must be no vpar running), stay connected to the console and interrupt the boot process within the 10 sec period.

[Mousa55]

Hi
you mean
MON>reset
and after that this message appeared "enter any key within 10 sec "
thanks

[Mousa55]

Hi
you mean
MON>reset
and after that this message appeared "enter any key within 10 sec "
and then all thing return As it were
thanks

[Torsten.]

after the "reset" command the system will do the selftests and end in BCH.
If autoboot flag is set, you will have 10 sec to interrupt - just press any key.

[Mousa55]

Hi
>"after the "reset" command the system will do the selftests and end in BCH"
I what will benefiting from this! i now in MON and want to return to BCH how?
thanks and best regards

[Torsten. · Accepted solution]

This is what I try to tell you:

No way back from MON to BCH - you need a reboot.

[Mousa55]

Hi
you mean did not need to this step
BCH>boot pri
ISL>hpux /stand/vpmon
directly to
MON>vparload -all
i am implementing this and the reboot it is
successfully
thanks and best regards