HPE Community
Operating System - HP-UX
1833777 Members
1935 Online
110063 Solutions
New Discussion

Re: Customizing installation using Ignite

 
Praveen R
Frequent Advisor

‎03-04-2004 12:43 AM

‎03-04-2004 12:43 AM

Customizing installation using Ignite

Hi,

Using Ignite i want to fully automate HPUX installation. I want to specify partition information for e.g: for root ("/") i want to specify 3GB and for "/home" 10GB. How do i do automate this in Ignite. Hope i am clear on the requirement.

Regards
Praveen R
0 Kudos
Reply
2 REPLIES 2
Robert Binkhorst
Trusted Contributor

‎03-04-2004 12:53 AM

‎03-04-2004 12:53 AM

Re: Customizing installation using Ignite

Hi,

You can change these settings in:
/opt/ignite/data/Rel_B.11.11/config

It's explained in detail here:
http://docs.hp.com/cgi-bin/fsearch/framedisplay?top=/hpux/onlinedocs/B2355-90788/B2355-90788_top.html&con=/hpux/onlinedocs/B2355-90788/00/00/16-con.html&toc=/hpux/onlinedocs/B2355-90788/00/00/16-toc.html&searchterms=ignite&queryid=20040304-064829

HTH,

Robert
linux: the choice of a GNU generation
0 Kudos
Reply
Sridhar Bhaskarla
Honored Contributor

‎03-04-2004 01:00 AM

‎03-04-2004 01:00 AM

Re: Customizing installation using Ignite

Hi Praveen,

It is clearly explained in the Ignite/UX document.

http://docs.hp.com/hpux/onlinedocs/B2355-90829/B2355-90829.html

Look at "Using Configuration Files" section. It is explained there with examples.

-Sri
You may be disappointed if you fail, but you are doomed if you don't try
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.