exec failed with ignite installation

[Catherine Forget]

Hi, I have a few w/s (15) to load and I have 2 problems:
Ignite verions is 4.4.30 and the w/s is a C3750.
1. I am trying to pull the image from my ignite server and it usually works. Now I am getting the ignite menu and after setting the keyboard and choosing Install HP-UX, I am getting into a Network recovery menu, which I do not want. I just waNT TO reinstall my w/s.


2. Here is the message :
Booting...
Network Station Address 00306e-481f40

System IP Address 160.223.147.250
Server IP Address 160.223.147.5

Boot IO Dependent Code (IODC) revision 2


HARD Booted.

ISL Revision A.00.43 Apr 12, 2000

ISL booting hpux (;0)/boot/INSTALL

Boot
: lan(10/0/12/0;0)/boot/WINSTALL
Exec failed
And it stops there.

Could you give me a hint to fix these 2 issues,

Thanks very much in advance

[T. M. Louah]

The problem is that the correct kernel (WINSTALL) was not put into the LIF area of the tape. check How-to document to put the make_net_recovery image to tape found at /opt/ignite/share/doc/makenetrec.txt.

Cheers,
TÂ

[Steven E. Protter]

Boot:

Interupt at the 10 second prompt.

boot lan.ip_address_of_ignite_server install

You must boot off the internal NIC card, not any add in or Gigabit cards.

The transfer can be on any NIC.

SEP

[Catherine Forget]

Hi, The image is on a disk of the igniteserver. There is no tape.

Steven: It is exactly what I have done, it is stops with the error.