Illegal instruction(coredump) error

[Cindy Wolford]

Hello hello!

We have an L3000 server with a new, cold install of 11.0.

We installed Ignite UX, made an ignite recovery tape, tested the tape for bootup....all looks ok.

We've setup a few uers in sam, no issues here.

All has been fine for the past week, no problems.

We just downloaded HP11e134 (Jet Direct for Unix) from the hp web site and installed this on our system today.

We then used the command /opt/hpnpl/bin/hppi and setup one printer, without any problems.

We went into sam to view the printer that we had configured, we set this printer as the default printer, exited sam.

We went back into sam, went back to the printers, and then we got this error:

UNEXPECTED EXIT: rocess LANG=C LC_ALL=C /user/sam/lbin/samx -C -p 9681 -s lp_printers /usr/sam/lib/lp.ui exited with a non-zero exit status.

sh: 9746 Illegal instruction(coredump).

Here is my swlist:
A5158A B.11.00.10 PCI Tachyon TL/TS Fibre Channel
A5230A B.11.00.05 100BT/9000 PCI
B5725AA B.3.6.83 HP-UX Installation Utilities (Ignite-UX)
B9073AA B.05.00 HP-UX iCOD-purchase (Instant Capacity on
HPUXEng64RT B.11.00.01 English HP-UX 64-bit Runtime Environment
HWE1100 B.11.00.0212.4 Hardware Enablement Patches for HP-UX 11
Ignite-UX-11-00 B.3.6.83 HP-UX Installation Utilities for Install
J4189-11001C E.10.34 Hewlett-Packard JetDirect Printer Instal
OnlineDiag B.11.00.23.10 HPUX 11.0 Support Tools Bundle, Dec 2002
QPK1100 B.11.00.58.5 Quality Pack for HP-UX 11.00, September
UXCoreMedia B.11.00.02 HP-UX Media Kit (Reference Only. See Des
UnlimUserLic B.11.00.02 HP-UX Unlimited-User License
XSWGR1100 B.11.00.47.08 General Release Patches, November 1999 (

If I check the status of JetDirect, it shows configured.

I was wondering if anyone had any suggestions on what we can do to correct this? We aren't 100% sure that installing the JetDirect is our problem.....but we haven't had an issue for the past week...so we are wondering if it's this software?

Any help/ideas/suggestions would be appreciated.

TIA!

[Helen French · Accepted solution]

Applying this new patch - PHCO_27375 (s700_800 11.00 cumulative SAM/ObAM patch) might solve your issue.

[Eugeny Brychkov]

Run
swlist -l fileset -a state
to see if there're all fileset configured. If not please run 'swlist \*'
Eugeny

[Fragon]

Use J4189-11001B instead!!!