Unable to Boot Intgrity Vm guest

[Sum_2]

Hi All,
I have created 2 Vm gustes on top of an RX2620. I have assigned 40GB virtual disks to each VM. In the VM i could install OS (11.23) from an iso image and the OS works fine without any issue. On the second VM, i installed the OS (using the same iso image which i used for loading the first Vm) but after the OS installation, the second Vm is unable to boot with throwing some errors. The errors are as follows. Can some one cam advice me if you ever faced this kind of issue?

gio: Error configuring root device using EFI hw paths
System Console is on the Built-In Serial Interface
WARNING: Open failed on device 0x1f010002 (error 0x16).
WARNING: Can not read LVM BOOT information (lvmrec).
WARNING: Open failed on device 0x1f010002 (error 0x16).
WARNING: Can not read LVM BOOT information (lvmrec).
WARNING: Open failed on device 0x1f010002 (error 0x16).
WARNING: Can not read LVM BOOT information (BDRA).
WARNING: SWAP device 0xfffffffe is a non-LVM partition, disallowed on LVM disk.
WARNING: SWAP device 0xfffffffe has been deconfigured (set to 0xffffffff).
WARNING: Logical volume for Dump expected but not found.
Swap device table: (start & size given in 512-byte blocks)
WARNING: no swap device configured, so dump cannot be defaulted to primary swap.
WARNING: No dump devices are configured. Dump is disabled.


Thanks,
Su

[Chandrahasa s]

Hi

Looks like you have not mentioned proper partiion sizes why cant you try again to load os on this guest.

Chandra