Operating System - HP-UX
1833883 Members
1672 Online
110063 Solutions
New Discussion

xstm not allowed to run Expert Tool

 
SOLVED
Go to solution
jerry1
Super Advisor

xstm not allowed to run Expert Tool

Why is Expert Tool "Run" grayed out from running in xstm?

I need to access C2300 array to change the
Auto-trespass to Enabled so HP-UX 11i CD
install does not lock up during I/O probe.

11.0 install CD shows why:

* Querying disk device: 6/0/0.4.0 ...NOTE: Cannot read from disk: /dev
/dsk/c5t4d0 (6/0/0.4.0): Invalid argument
(errno = 22). This is normal for LUN's that are not owned by the
controller indicated by the HW path. This disk will not be available
for use during the install.
1 REPLY 1
melvyn burnard
Honored Contributor
Solution

Re: xstm not allowed to run Expert Tool

If I recall, it requires and HP ONLY password to enable the Expert Tool portion on STM.
You would need to get the assistance of your HP Response Centre, or your HP engineer
My house is the bank's, my money the wife's, But my opinions belong to me, not HP!