ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Re: Cannot enter Standby Mode on HP ProLiant DL380 G4

 
SOLVED
Go to solution
Highlighted
Occasional Contributor

Cannot enter Standby Mode on HP ProLiant DL380 G4

Since I removed the defective Cache Module from The Smart Array 6400 controller, the server will never enter standby mode. The power LED is off but the fans are still very very noisey, can someone help me with this issue. Also, the HDDs keep spinning after the server is 'off'

3 REPLIES 3
Highlighted
HPE Pro
Solution

Re: Cannot enter Standby Mode on HP ProLiant DL380 G4

Hello,

I hope you are doing well.

For fan noise or running high speed so many reasons.

  1. Bios should be updated with the latest.
  2. All the firmware ( ILO & Smart Array (SA) firmware, as well as hard disk firmware, should be updated with the latest.
  3. Use only HPE certify, Supported or tested components.
  4. Remove Non-HPE hardware components from the server, if you are using. 

Please share the error if you are getting any error message.

If you feel this was helpful please click the KUDOS! thumb below!   

Regards,


I am a HPE Employee

Accept or Kudo

Highlighted
Occasional Contributor

Re: Cannot enter Standby Mode on HP ProLiant DL380 G4

Hello,

Thank you so much for your reply, turned out I needed to update the Bios.

 

Once again, thank you very very much

Hope you all stay safe

Frank

Highlighted
HPE Pro

Re: Cannot enter Standby Mode on HP ProLiant DL380 G4

Hello,

Thank you for your reply.

If you feel this was helpful please click the KUDOS! thumb below!   

Regards,


I am a HPE Employee

Accept or Kudo