- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers (ML,DL,SL)
- >
- DL360 & DL380 Servers on 3 Phase power
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-12-2018 07:23 AM
09-12-2018 07:23 AM
DL360 & DL380 Servers on 3 Phase power
Hi,
We are updating our electrics and have installed new 32amp single phase circuits to each of our server racks, and attached them to new HPE PDUs.
Some of the new circuits are on the same electrical phase as the old circuits, so we have managed to move the dual powered servers to the new power without switching them off.
Some of the new circuits are on a different power phase to the old circuit. Is it possible to move one power cord from the old circuit (say Phase L1) to the new circuit (say Phase L2) and then move the second power cord over, so as to avoid shutting down the servers?
Kind regards.
Dan.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-14-2018 01:02 AM
09-14-2018 01:02 AM
Re: DL360 & DL380 Servers on 3 Phase power
Hello Dan,
Greetings.
Make sure the Old & the New circuits do have required power to the Servers & the Servers do have dual power supplies installed. If there are no fluctuations on the power line to the servers, then you can move the power cords one by one to avoid shutting down the servers.
Thank you
Warm Regards.
I work for HPE
I am an HPE employee