HPE Community
ProLiant Servers (ML,DL,SL)
1753776 Members
7254 Online
108799 Solutions
New Discussion

Re: Drives must be connected/configured as standalone drives

 
Torsten.
Acclaimed Contributor

‎11-27-2019 07:18 AM

‎11-27-2019 07:18 AM

Re: Drives must be connected/configured as standalone drives

Your software can handle software RAIDs only anyway.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
mikethelad
Occasional Advisor

‎11-27-2019 07:24 AM

‎11-27-2019 07:24 AM

Re: Drives must be connected/configured as standalone drives

I am happy to try any other recovery software tat you think could work better

0 Kudos
Reply
rmay_bk
Valued Contributor

‎11-27-2019 10:14 AM - edited ‎11-27-2019 10:15 AM

‎11-27-2019 10:14 AM - edited ‎11-27-2019 10:15 AM

Re: Drives must be connected/configured as standalone drives

I would try HBA mode regardless.  Recovery software that performs direct reads, sector by sector, against the drives might still be able to recover something even if the drives are not formally recognized by the controller.

OP's specific software may not be able to handle hardware RAID arrays but some other forensic recovery software just might.

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.