HP Proliant DL360 Gen9 SSD controller configuration

[MickyM]

Hi

Sorry i'm a bit of a newb when it comes to these things, but i was hoping someone could point me in the right direction.

We had a server installed which has 6 SSDs,

5 are assigned to the Smart Array P440ar Controller.

1 is assigned to the Dynamic Smart Array B140i controller.

I want all 6 to be managed by the P440ar controller so i can use them all in 1 RAID array. How do i achieve this?

Thanks

Mick

[Torsten.]

Not sure if this current config is even supported ... all disks (is it a 8SFF system?) should be connected to a single controller.

However, open the chassis and check if both SAS cables are connected to the smart array controller.

[MickyM]

thanks for the fast response.

Not sure what you mean by 8SFF system.

All we want is to have the 6 x 480GB SSDs on the same controller so we can use them all in a RAID  array.

Are you saying this desired config is not supported? or the the current config is not support, i.e 1 SSD to B140i/5 SSDs to P440ar?

[Torsten.]

8SFF - 8 small form factor disks (2,5")

I doubt about your current config ...