ML110 Gen10 s100i SW RAID Support Not Working

[sdrake48]

If Configure s100i integrated controller for SW RAID Support (via system settings), then Storage Administrator detects NO controller and NO hard drive.  If change system setting for s100i to AHCI SATA support, then can install Windows 2012R2 and boot it.  If leave setting at SW RAID Support, then restore a functioning sysprepped Windows 2012R2 image, Windows will try to boot and then ask for original install media to run Repair - but eventually fails because 'drive is locked'. HP Support unable to help so far - just emails the instructions from the manual on using SW RAID Support - haven't convinced them yet that when using this setting the SSA sees no smart array controller. Anyone have any success with ML110 Gen10, UEFI, s100i set to SW RAID Support and LFF SATA drives?

[Psuedo_Random]

I am having this same issue. Did you ever get a resolution from HP?

[FauconLeTEIL]

I have the same issue. I'm using one LFF HP hard drive. Even when I choose SATA AHCI in RBSU, SSA sees no smart array controller !

[GregC1]

same thing here, it wont load drivers in Windows 

[GregC1]

i got it to work, i HAD to copy either CP030473 or CP032245 to a USB thumb drive and plug into front bottom right USB port and got drivers to load in windows setup, could not use ILO virtual drive folder for the drivers, they would fail loading

[sangamc]

Hi GregC1

I am new to HPE and despreate to figure out how you did this.